Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

Series 2 - T-2A cavity, Viton, cartridge seal kit

Expand All

Technical Features [ + ]

The shelf life for this cartridge seal kit is twenty years from date of purchase. This date will be printed on the kit packaging.

Cartridge Installation Data [ + ]

Series	2
Installation Torque	45 - 50 lbf ft61 - 68 Nm
Cartridge Thread	1"-14 UNS1"-14 UNS
Kit Type	Date Stamped Dec. 31, 1985 or earlier (3/32" cross section)Date Stamped Dec. 31, 1985 or earlier (3/32" cross section)
Valve Hex Size	1 1/8 in.28,6 mm
Cavity	T-2A

Notes [ + ]

Install back-up rings and O-rings as shown in views.
See installation variations for models associated with alternative installation views.
When installing continuous back-up rings, use the same technique and the same care used to install O-rings.
When installing cartridge - be sure to torque to recommended value.
During 1985, SUN made a running change of all external seals on Series 2 cartridges (1-1/8 in. (28,6 mm) hex, 1-14 thd). The seals were changed from 3/32 in. (2,62 mm) c/s to 1/16 in (1,7/8 mm) c/s o-rings and backup rings.
Use the kit which contains the same size (c/s) seals as those used on the cartridge being repaired. Do not change cartridge o-ring c/s sizes.

Additional Resources [ + ]

Technical Information

990102006 | Accessories » Cartridge Seal Kits | Sun Hydraulics

Assembly Build Process

Assembly Build Process

Series 2 - T-2A cavity, Viton, cartridge seal kit

Footer