Rojo operación doble de girar/bloquear, activador manual juego de control, control D

991242 : Rojo operación doble de girar/bloquear, activador manual juego de control, control D
Technical Features [ + ]

The Twist/Lock manual override is a rotary, hand-actuated device for use on Sun's full flow solenoid valves and certain Series P models. The hand knob is constructed of a reinforced red plastic for durability, heat resistance and stability in varying environmental conditions and is suitable for operation with a gloved hand. The override assembly incorporates a sealed-construction design thereby preventing the introduction of debris and other damaging contamination. Once installed on a Sun solenoid valve, the override feature allows the operator to manually shift the de-energized valve. The red D control is available in kit form only and cannot be configured with the cartridge. Please note that valves with the Twist/Lock manual override are not suitable for load holding applications.

  • The dual operation override option "D" allows the operator to either shift momentarily by turning clockwise or place it in the detent postion by turning counter-clockwise.
  • The manual control assembly has a mechanical life expectancy of approximately 7,000 cycles.
Technical Data [ + ]
Material Red plastic and aluminumRed plastic and aluminum
Description Dual (Twist/Lock) Operation (Option D)Dual (Twist/Lock) Operation (Option D)
Operating Torque 10 lbf in.1,2 Nm
Used With [ + ]

What models can this kit be used with?

  • DNDYS 2-posiciones , 6-vías, cambio suave , direccional, operada por solenoide carrete válvula
  • FMDA Electro-proporcional 3-vías control de caudal válvula , alimentación regulada
  • FMDB Electro-proporcional 3-vías control de caudal válvula , alimentación regulada
  • FPCC Electro-proporcional control de caudal válvula - normalmente cerrado
  • FPCH Electro-proporcional control de caudal válvula - normalmente abierto
Notes [ + ]
  • Ensure o-ring is installed in bottom of the manual override assembly.
  • Remove existing coil nut from end of solenoid tube.
  • Thread the manual override assy on to the end of the solenoid tube. Point coil connector in desired position before hand tightening the manual override assy.
  • Note: Thread lock may be used if anticipated conditions warrant.
Additional Resources [ + ]