T-11A cavity, weatherized coil seal kit

991060 : T-11A cavity, weatherized coil seal kit
Technical Features [ + ]

This weatherization kit is used in conjunction with a weatherized coil and a modified cavity (see below). The coil is not included in the kit and must be purchased separately. Weatherization kits are cartridge model code dependent. This kit is intended for new installations only and is not suitable for retrofitting existing equipment, or for standard Sun bodies. A selection of special line mount bodies for use in weatherized assemblies are available.

Technical Data [ + ]
Seal Material VitonViton
Valve Hex Size 7/8 in.22,2 mm
Valve Installation Torque 30 - 35 lbf ft41 - 47 Nm
Used With [ + ]

What models can this kit be used with?

  • PRDM Electro-proportional, direct-acting, pressure reducing/relieving valve with open transition - high pressure setting with no command
  • PRDN Electro-proportional, direct-acting, pressure reducing/relieving valve, high pressure setting with no command
  • 773812 12 VDC weatherized coil with Metri-Pack, Series 150-2M connector
  • 773814 14 VDC weatherized coil with Metri-Pack, Series 150-2M connector
  • 773824 24 VDC weatherized coil with Metri-Pack, Series 150-2M connector
  • 773828 28 VDC weatherized coil with Metri-Pack, Series 150-2M connector
  • 773836 36 VDC weatherized coil with Metri-Pack, Series 150-2M connector
Notes [ + ]
  • Machine cavity spotface as shown in the Related Information section. Proper locating shoulder depth from bottom of spotface MUST be maintained. (When using Sun manifolds designed for weatherized assemblies, this step can be skipped.)
  • Remove existing coil nut and o-ring from cartridge and discard or save for other use.
  • Install cartridge into manifold to specified torque.
  • Install spacer, coil, and associated o-rings in order shown. Torque coil nut to 30-35 in-lbs.
Additional Resources [ + ]