Filter

Capacity: 10 gpm40 L/min. | Cavity: T-13A
FLDA : Filter
Technical Features [ + ]

Sun filter elements are available as Surface Type (Last Chance) and Depth Style elements. The flow path is Port 2 to Port 1 and should not be used in reverse, even with a reverse free flow check valve installed. The elements have a high collapse pressure and are intended to be used in line with the system. Filter life will depend on initial system cleanliness and the amount of dirt ingression to the system when operating.

  • Installation directly above the subplate will protect the entire valve stack from particles.
  • Differential crush pressure is 3000 psid (210 bar).
  • The flow path is Port 2 to Port 1 only.
  • Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage the seals.
  • Surface Type elements are designed to capture errant particles that may not be trapped in the main system filter or particles resulting from a component failure.
  • With a correctly assembled system, Surface Type elements will be unnoticed during regular operation, but will provide protection from sudden component failure.
  • Surface type element features a 304 stainless steel mesh media. All internal components are 304 stainless steel.
  • Surface Type elements have a 40 micron nominal rating (63 micron absolute).
  • Surface Type (Last Chance) elements have a single layer stainless steel mesh supported by perforated sheet tube.
Technical Data [ + ]
Note: Data may vary by configuration. See CONFIGURATION section.
Cavity T-13A
Series 1
Capacity 10 gpm40 L/min.
Maximum Operating Pressure 5000 psi350 bar
Valve Hex Size 7/8 in.22,2 mm
Valve Installation Torque 30 - 35 lbf ft41 - 47 Nm
Seal kit - Cartridge Buna: 990010007
Seal kit - Cartridge EPDM: 990010014
Seal kit - Cartridge Polyurethane: 990010002
Seal kit - Cartridge Viton: 990010006
Performance Curves [ + ]
FAQs [ + ]

There are exactly 250 Sun drops in a cubic inch or 15 in a cc.

Notes [ + ]
  • See Related Accessories for replacement elements.
Additional Resources [ + ]